Versions 1, 2, 3 and 4 are no longer for sale, replaced by v5 which is compatible with the previous ones. 433mhz Rolling Code (enhanced security) 4 channels = ability to control 4 doors or 4 ONE automations Compatible with ONE D and ONE X motors Attention:Compatible only with our ONE motorsNot compatible with FUTURCOM motors 10€ offered When purchasing at least two remote controls It's automatic ;)

Open your door with a secret code (3 to 8 digits). Convenient for opening your door without a remote control Easy to install, just screw it in Long transmission range 433mhz Rolling Code transmission (enhanced security) 2 channels = ability to control 2 doors/ONE automations 2 3V CR2032 batteries (included) Note, specific coding for ONE motors of our own brand.

This receiver makes your garage door motor compatible with connected systems. You can open your door, close it and check its status from your smartphone with voice command, on the Meross (Android / iOS) or Apple Home app. Easy to install, it is connected to the motor on the terminals for the push button, a wired sensor detects the position of the door and it is supplied by a power outlet.

Backup Battery for Motor ONE (the unit) Convenient, in case of a power outage, your ONE motor will still operate. Lithium Battery Power: 24V 1.5 Ah Dimensions: approximately 160x100x50 mm Attaches above the motor head (or if that is not possible, it can be fixed to the ceiling with one anchor)

Photocell Barrier for Motor One with adjustable support. Ensures the safe descent of your garage door. An obstacle in front of the cells will stop its closure.  A pair of cells (one emitting cell + one receiving cell)  Two adjustable supports (allowing for easier and more precise alignment and adjustment, even with uneven and non-parallel walls)

To be installed on the automation to be controlled Makes your motor compatible with our ONE transmitters/keypad Frequency 433mhz 2 ONE V5 transmitters (optional) Easy to implement     - 2 wires => 12 /24V     - 2 wires => dry contact on PUSH BUTTON / START input Mini size: 65mm x 45mm x 25mm

Garage door motor bracket to be placed on the spacer crossbar at the back of the door tracks (crossbar not supplied) This support allows the rear fixing of your motor rail, directly on your spreader bar. Which is very useful if your ceiling is high and out of reach of angles. Designed for a 55 to 81mm wide motor rail .  Contents of the kit: 1 black lacquered support  1 cavalier rail ONE 4 M8 bolts

Yellow LED flashing lamp Recommended for garage doors and courtyard gates opening directly onto a street: warns when closing or opening. 2 possible voltages according to installation : Continuous 12V to 30V Alternative 90V to 260V 2 different ignitions : Fixed* / Flashing (* provided that the output of your motor is not already flashing by default )