Sectional garage door insulated 60mm, 2 sides steel 0.35mm polyurethane foam.
This two-seater sectional garage door is delivered with ball bearing or double rollers for custom heights. The pulleys are made of Nylon overmolded steel for extended life. At the bottom of the door, an EPDM bead gasket provides maximum insulation, coupled with 60mm thick panels. This gasket also absorbs slight deformations of the floor under the door.
This sectional door is delivered to you in a pack (assembled entirely in the factory and then partially disassembled for transport) with illustrated assembly instructions in French, written by our design office (see Documentation tab).
Coefficients of thermal resistance
Ud = 0.51 W/m²K for single panel
Ud = 0.90 W/m²K for the complete deck (= assembled panels)
Ud = 1.43 W/m²K for an installed door, taking into account the installation on a standard substrate.
Dimensions
Available in 10 standard sizes:
W2400 / 2500 / 3000 / 4000 / 5000 mm and H2000 / 2125 mm
or custom-made:
Width from 2000mm to 5000mm
Height from 1850mm to 2250mm
The minimum distance between the mounting brackets for this sectional door is 75 mm (see measurements 3 and 4 in the dimensional drawing). The lintel drop must be at least 160 mm (measure 5 on the diagram).
The + products
Excellent thermal and sound insulation with 60mm panels
A very wide door
Fully mechanical anti-lift safety device on the engine
No external overflow
Robust steel mechanics
Motorized with 2 remote controls & very simple settings